问题描述
烧录完成后串口日志如下：
U-Boot SPL 2022.10-00009-ga4b0ed0a (Aug 29 2025 - 09:53:25 +0000)
lpddr4 2660
00000000: PMU Major Msg: End of CA training
00000000: PMU Major Msg: End of initialization
00000000: PMU Major Msg: End of read enable training
00000000: PMU Major Msg: End of fine write leveling
00000000: PMU Major Msg: End of read dq deskew training
00000000: PMU Major Msg: End of MPR read delay center optimization
00000000: PMU Major Msg: End of Write leveling coarse delay
00000000: PMU Major Msg: End of write delay center optimization
00000000: PMU Major Msg: End of read delay center optimization
00000000: PMU Major Msg: End of max read latency training
00000000: PMU Major Msg: Firmware run has completed
[2025-09-12 13:53:19.074]# RECV ASCII/81 <<<
Error, load image failed.4
uboot boot failed 4
spl_board_init_f() failed: 4
[2025-09-12 13:53:19.184]# RECV ASCII/82 <<<
resetting ...
reset not supported yet
ERROR ### Please RESET the board
复现步骤
切换BOOT
boot0=1
boot1=1
选择EMMC作为烧录目标
烧录完成后
切换BOOT
boot0=0
boot1=1
启动
硬件板卡
G6700
软件版本
CanMV_K230_GT6700_micropython_v1.4-2-g873d625_nncase_v2.9.0
